Hot water heaters are one of a household’s most diligently operating appliances. Day or night, it’s making perfectly heated water anytime you would like it. When it suddenly is no longer working adequately, most of us usually tend to worry.

Thankfully a nonfunctioning water heater does not constantly imply an expensive repair. Prior to making an emergency call to Haynes Plumbing, we recommend checking the trouble yourself first.

Bethesda Water Heater Repair Troubleshooting

Pilot Light CheckBethesda Water Heater Repair

For gas water heaters first take off the small panel which is found on the bottom of the appliance and look to see if the pilot light is illuminated.
See if may ignite if it is not lit. If it remains lit, one should be able to hear that the water heater ought to start working effectively once more. The pilot light might possibly need cleaned out or the thermocouple might require to be replaced if perhaps the pilot light will not remain ignited.

Thermocouple Replacement

The term thermocouple might seem like a incredibly technological name, but it’s a component on ones water heater that can easily be replaced. Haynes Plumbing would suggest having us perform the replacement but the steps below are for educational purposes.

Refer to the owner’s manual. It ought to have instructions for ways to remove and change the thermocouple.
Switch off the gas before removing anything at all from the water heater.
Following the directions in your individual’s manual, remove the thermocouple by separating it from both sides of the pilot light. The brand new thermocouple on the water heater ought to be cut to the correct length.
The gas may then be switched back on and examine for leaks, then the pilot light can be lighted once again.

Press the Water Heater Reset Button

For property owners with an electric water heater, look for the position of the reset button and press it until a click is heard.
If a click is definitely not observed, or it fails to restart the water heater, reset the breaker.
If a breaker reset does not do the trick, the thermostat most likely will require being replaced.

Thermostat Replacement

Both the power to the water heater and the switch on the breaker will require being turned off. Safe practices with electricity is required to be used!
Use the owner’s manual to locate the thermostat wires, then disconnect them.
After removing the thermostat we will evaluate to find out its condition. If it is damaged, we will have to change it.

Heating Element Replacement

With the power still switched off, the access panel on the water heater can be opened up.
The terminal screws can be loosened and the wires may be pulled away from the heating element.
We would next test every component of the element to check if they are faulty, and replace them as necessary.

These water heater troubleshooting methods ought to help get ones heater going once more. Haynes Plumbing is obviously here for helping, therefore don’t hesitate to get in touch with us today for any Water Heater Repair Bethesda help.